Spiega documentation

Article: coiler

What spiega is about

coiler

This project describes the creation of a coiler which is a device to wind a thin copper wire around magnets to create pickups and exciters for e-bows.

hardware

The coiler needs one arduino, a servo motor and a DC motor.
The magnet is attached to the DC motor and a thin copper wire is attached to its bottom.
While the DC motor spins the servo motor moves the wire up and down to allow a regular distribution across the magnet.
An MCU:

A coiled winds copper wire around a magnet to create a pickup and a sustainer.

coiler

structure of the coiler

wiring

wiring the magnet

coiler

coiler

we connect almost all free pins to an arduino micro.

tuning

tuning

We tune the range of the servo motor, the speed of the dc motor

inline

inline

We put the copper coil, the tension control, the servo motor and the dc spin motor in line.